project requirements

We were approached by our client a design and build contractor who was on site already undertaking a design and build refurbishment. The lighting layout was decided by the main client based on the area remaining as a CAT A space. Within the ground floor space, the linear luminaires were recessed into the MF ceiling and in the lower ground floor they were suspended from the underside of the existing concrete slab. Some of the M–Line linear Recessed luminaires were installed as continuous runs up to 17m long!

An impressive element of the project was an additional space to a large office with a high ornate ceiling which couldn’t be disturbed due to the grade II listing of the building.  The ceiling detail meant it would be difficult to install lighting points. Our solution to this challenge to was to utilize the existing lighting feed located at high level to the side of the roof window and build a bespoke rectangle carefully sized at 7.130m x 3.630m to be supported by the timber edge. Within the rectangle we included 2 no. presence detectors to activate the lighting on entry. Dimming and override switching was achieved by incorporating DALI eBlue modules within the luminaire which enabled the roof light feature to be switched and dimmed via a wireless wall switch.

Products Utilised

M-Line Recessed System - 170m c/w integral emergency packs and DALI Dimmable LED drivers M–Line Suspended System - 120m c/w integral emergency packs and DALI Dimmable LED drivers M–Line Bespoke System - 7.130m x 3.630m Suspended Rectangle c/w direct and indirect lighting incorporating DALI Dimmable LED drivers, eBlue Bluetooth control modules and CP electronics presence detectors.
Close up suspended M-Line Linear LED
large bespoke LED Rectangle

Project Conclusion

The outcome of this project was seriously impressive with the lighting creating a modern statement in this historic building ready to delight new incoming tenants.

get in touch about a project now.